oakview2
Junior Member
https://www.facebook.com/groups/GOLDAU/
Posts: 52
|
Post by oakview2 on Sept 20, 2014 11:26:36 GMT -5
|
|
oakview2
Junior Member
https://www.facebook.com/groups/GOLDAU/
Posts: 52
|
Post by oakview2 on Sept 20, 2014 11:27:51 GMT -5
|
|
oakview2
Junior Member
https://www.facebook.com/groups/GOLDAU/
Posts: 52
|
Post by oakview2 on Sept 20, 2014 11:28:59 GMT -5
|
|
oakview2
Junior Member
https://www.facebook.com/groups/GOLDAU/
Posts: 52
|
Post by oakview2 on Sept 20, 2014 11:31:39 GMT -5
|
|
|
Post by ywevis on Sept 21, 2014 2:20:57 GMT -5
Looks pretty interesting, is that someone's claim?
|
|
oakview2
Junior Member
https://www.facebook.com/groups/GOLDAU/
Posts: 52
|
Post by oakview2 on Sept 21, 2014 9:34:06 GMT -5
It is a club claim.
|
|
oakview2
Junior Member
https://www.facebook.com/groups/GOLDAU/
Posts: 52
|
Post by oakview2 on Sept 21, 2014 17:50:17 GMT -5
|
|
oakview2
Junior Member
https://www.facebook.com/groups/GOLDAU/
Posts: 52
|
Post by oakview2 on Sept 21, 2014 17:50:59 GMT -5
|
|
|
Post by ywevis on Sept 21, 2014 21:16:50 GMT -5
Nice gold in them tailings. I would run them again lol
|
|
oakview2
Junior Member
https://www.facebook.com/groups/GOLDAU/
Posts: 52
|
Post by oakview2 on Sept 22, 2014 8:42:32 GMT -5
This site has a lot of free milling gold, but a ton of it is locked in sulfides. We have mechanical run the majority of the best ore, next will be to start milling the sulphides, as there is a tremendous amount of gold locked up in the, small and needs to be liberated. If we can accomplish that we will start working a part of the vein that was exposed by a slide up the hill. Ambitious as it is fairly remote and rough.
|
|
|
Post by ywevis on Sept 22, 2014 19:45:13 GMT -5
What are you using to crush the rocks?
|
|
oakview2
Junior Member
https://www.facebook.com/groups/GOLDAU/
Posts: 52
|
Post by oakview2 on Sept 23, 2014 0:54:54 GMT -5
Most all of the gold recovered so far has been either highbanked or detected out of a go back pile that has been through a arastra. A small amount was run through a Keene Rotary crusher. We are about to build a Ball Mill out of a cement mixer with tires linning the tub to save on wear and tear. Need to shut down and clear our placer op first as it is at 5500 feet in elevation, and after the first big snow, they lock the gate..
|
|